How to install.

About two minutes. You don't unscrew anything and you don't touch any wires: the cover goes on top of the switch or socket you already have.

📦in the bag: the cover, one lever per key, tape squares🧻you need: a tissue with a drop of alcohol or soapy water

Step by step

Why it works

  • The cover sits on your frame, not on the key. Inside it is hollow, so the key underneath keeps rocking freely.
  • The lever is the key's new handle. It is glued to the middle of the key and comes out through the slot. Press it up or down, and the key switches like before.
  • It fits because it is made for your frame. The cover is made to your width and height with a 0.4 mm gap per side, so it holds by friction. Its depth is your measured D plus 5 mm, which leaves room for the key to move.

Can't find the middle of the key? Do it the other way round. Stick the tape on the flat part of the lever, push the lever's stick through the slot from inside the cover, then push the cover onto the frame. The lever lands exactly where it should. Press the stick for 30 seconds.

coverrests on your frameyour framestays as it isyour keystill rocks insidetapelever, 17 mm outpress it up or downglued to the keywallyour D + 5 mm
Side cut, to scale

Taking it off

Pull the cover straight off the wall. The lever usually comes off with it. Rub any leftover tape off the key with your thumb. Your switch is exactly as it was. Moving it to a new home? Stick the lever back with a fresh square of double-sided mounting tape.

If something is off

The key feels stiff or doesn't clickThe lever is off-centre and rubs on the edge of the slot. Take the cover off, peel the lever and stick it back in the middle of the key (or use the trick above).
The cover doesn't reach the wallSomething on the frame sticks out more than was measured. Check D again: from the wall to the highest point of the key. Write to us with a photo from the side.
The cover is looseThe frame is a little smaller than measured. A small piece of tape on the edge of the old frame holds it. If it wobbles more than a millimetre, send us a photo.

Safety: the cover goes on top of the existing frame. Don't remove the frame and don't cover a switch that is cracked or shows wires. Get that repaired first.