How to measure.
A Knappa cover slips over the frame you already have. To make it sit snug, we need three numbers in millimetres. It takes two minutes, and you don't unscrew anything.
1Width and height
Lay the ruler flat on the frame. Measure the plastic frame around the key, from the outer left edge to the outer right edge. Then do the same from top to bottom.
- Measure the frame, not the key and not the box in the wall.
- Most EU frames are square, so W and H are usually the same. Measure both anyway.
- Write exactly what you see, to 0.5 mm. Don't add any margin. We add the fit gap ourselves.
2Rounded or bevelled edges
Many frames are soft, rounded or have a slanted edge. A ruler lying on top then shows a smaller number than the real size.
Measure across the widest points, where the frame meets the wall. Hold the ruler right against the wall, or hold two flat things (two cards) against the sides and measure between them.
3How far it sticks out
- Put the ruler next to the switch, zero against the wall, pointing straight out at you.
- Lay the card flat on the highest point of the key, parallel to the wall, so it reaches the ruler.
- Read where the card crosses the ruler. That's D.
- A rocker key tilts. Measure the side that sticks out more.
- Measure to the key, not just the frame. The cover has to clear the key.
- Sockets: measure to the highest point, usually the rim around the holes.
4Frame for 2 or 3
On a multi-frame (two switches side by side, switch + socketβ¦) you can't measure one section on its own. So:
- Measure the short side. Across a horizontal row that's the height, H.
- Measure the full length of the frame.
- Take away 71 mm for every extra section. That's W for one section.
| sections | one section = |
|---|---|
| 2 | full length β 71 |
| 3 | full length β 142 |
4 in a row: not yet. A cover that long is too big for us to make, for now.
Example: 3 in a row, full length 228 mm β 228 β 142 = 86. Or let the calculator below do the maths.
Vertical column? Same, but it's the full height you shorten.
Why 71: across Europe, the boxes in the wall sit 71 mm apart, centre to centre.
Know your brand? Shortcut.
Pick the series in the configurator and W and H fill in for you. Then you only measure D. The brand is usually printed on the frame's bottom edge or on the key.
Not in the list (Liregus, Vilma and other local brands)? Measure with a ruler; it's the same two minutes. Even with a preset, a quick check with a ruler doesn't hurt: series of one brand differ.
Six mistakes we see most
The configurator checks your numbers and warns you if something looks off: a frame under 78 or over 92 mm, or D outside 7β16 mm.
What fits
β Yes
β Not yet
Not sure about yours? Send us a photo of it from the front and from the side before you order. We'll tell you honestly whether it fits.
Got your numbers? Let's build it.
Type what you measured. We do the maths and open the configurator with your size filled in.
Safety: a cover goes on top of the existing frame. Don't remove the frame or touch anything behind it. That's a job for an electrician.